« Previous -
Version 2/16
(diff) -
Next » -
Current version
J. Simmons, 04/30/2018 06:34 pm
Sensor Assembly¶
Tools¶
- Holoseat Test Stand with computer to operate it
- Soldering iron with stand
- Helping hands
- Exhaust fan
- Sensor assembly jig (3D printed tool - provide link)
- Flush snips
- Safety glasses
Materials¶
- Instant/super glue (prefer Loctite Super Glue Ultragel Control)
- Solder
- (1) WSSM-01: TRRS Audio Connector on PCB
- (1) WSSM-02: TLE4966L Infineon Technologies High Precsn Hall / Board Mount Hall Effect/Magnetic Sensors
- (1) WSSM-03: Sensor Housing Lower Half
- (1) WSSM-04: Sensor Housing Upper Half
- (1) WSSM-05: 3M 9472LE Tape 1/2" x 1" piece
Safety Issues¶
- Care must be taken when using the soldering iron, the tip is very hot
- Always wear safety glasses while working with soldering irons
- Avoid breathing in the soldering fumes, use a vent or hood if needed to provide adequate ventilation
Product¶
HS-04: Wheel Speed Sensor Module