Sensor Assembly¶

• Sensor Assembly
  • Tools
  • Materials
  • Safety Issues
  • Product
  • Procedure
    • 1. Place sensor on board (need specific name)
    • 2. Solder sensor to board
    • 3. Verify sensor
    • 4. Finish assembly

Tools¶

• Holoseat Test Stand with computer to operate it
• Soldering iron with stand
• Helping hands
• Exhaust fan
• Sensor assembly jig (3D printed tool - provide link)
• Flush snips
• Safety glasses

Materials¶

• Instant/super glue (prefer Loctite Super Glue Ultragel Control)
• Solder
• (1) WSSM-01: TRRS Audio Connector on PCB
• (1) WSSM-02: TLE4966L Infineon Technologies High Precsn Hall / Board Mount Hall Effect/Magnetic Sensors
• (1) WSSM-03: Sensor Housing Lower Half
• (1) WSSM-04: Sensor Housing Upper Half
• (1) WSSM-05: 3M 9472LE Tape 1/2" x 1" piece

Safety Issues¶

• Care must be taken when using the soldering iron, the tip is very hot
• Always wear safety glasses while working with soldering irons
• Avoid breathing in the soldering fumes, use a vent or hood if needed to provide adequate ventilation

Product¶

HS-04: Wheel Speed Sensor Module

Procedure¶

1. Place sensor on board (need specific name)¶

2. Solder sensor to board¶

3. Verify sensor¶

4. Finish assembly¶