Holoseat

h1. Sensor Assembly

{{>toc}}

h2. Tools

* Holoseat Test Stand with computer to operate it
* Soldering iron with stand
* Helping hands
* Exhaust fan
* Sensor assembly jig (3D printed tool - provide link)
* Flush snips
* Safety glasses

h2. Materials

* Instant/super glue (prefer Loctite Super Glue Ultragel Control)
* Solder
* (1) WSSM-01: TRRS Audio Connector on PCB
* (1) WSSM-02: TLE4966L Infineon Technologies High Precsn Hall / Board Mount Hall Effect/Magnetic Sensors
* (1) WSSM-03: Sensor Housing Lower Half
* (1) WSSM-04: Sensor Housing Upper Half
* (1) WSSM-05: 3M 9472LE Tape 1/2" x 1" piece TBD

h2. Safety Issues

* Care must be taken when using the soldering iron, the tip is very hot
* Always wear safety glasses while working with soldering irons
* Avoid breathing in the soldering fumes, use a vent or hood if needed to provide adequate ventilation TBD

h2. Product

HS-04: Wheel Speed Sensor Module assembly (insert part number)

h2. Procedure

h3. 1. Place sensor on board (need specific name)

h3. 2. Solder sensor to board

h3. 3. Verify sensor

h3. 4. Finish assembly