h1. Sensor Assembly

{{>toc}}

h2. Tools

* Holoseat Test Stand with computer to operate it
* Soldering iron with stand
* Helping hands
* Exhaust fan
* Sensor assembly jig (3D printed tool - provide link)
* Flush snips
* Safety glasses

h2. Materials

* Instant/super glue (prefer Loctite Super Glue Ultragel Control)
* Solder
* (1) WSSM-01: TRRS Audio Connector on PCB
* (1) WSSM-02: TLE4966L Infineon Technologies High Precsn Hall / Board Mount Hall Effect/Magnetic Sensors
* (1) WSSM-03: Sensor Housing Lower Half
* (1) WSSM-04: Sensor Housing Upper Half
* (1) WSSM-05: 3M 9472LE Tape 1/2" x 1" piece

h2. Safety Issues

* Care must be taken when using the soldering iron, the tip is very hot
* Always wear safety glasses while working with soldering irons
* Avoid breathing in the soldering fumes, use a vent or hood if needed to provide adequate ventilation

h2. Product

HS-04: Wheel Speed Sensor Module

h2. Procedure

h3. 1. Place sensor on board (need specific name)

h3. 2. Solder sensor to board

h3. 3. Verify sensor

h3. 4. Finish assembly