Holoseat

h1. Controller Assembly

{{>toc}}

h2. Tools

* Holoseat Test Stand with computer to operate it

* Soldering iron with stand

* Helping hands

* Exhaust fan

* Flush snips

* Safety glasses

h2. Materials

* Instant/super glue (prefer Loctite Super Glue Ultragel Control)

* Solder

* (1) HSC-01: Feather

* (1) HSC-02: Holoseat Controller Wing

* (1) HSC-03: Controller Housing Base

* (1) HSC-04: Controller Housing Top

* (1) HSC-05: 12 pin header

* (1) HSC-06: 16 pin header

* (1) HSC-07: Holoseat Custom Key Cap

* (1) HSC-08: TRRS Wing

* (1) HSC-09: Keyswitch

* (1) HSC-10: Controller Housing Mounting Slot

h2. Safety Issues

* Care must be taken when using the soldering iron, the tip is very hot

* Always wear safety glasses while working with soldering irons

* Avoid breathing in the soldering fumes, use a vent or hood if needed to provide adequate ventilation

h2. Product

HS-02: Controller

h2. Procedure

h3. 1. Prepare Mounting Slot

# Do a test fit (without glue) of the *HSC-03: Controller Housing Base* and *HSC-10: Controller Housing Mounting Slot* by sliding the *Controller Housing Base* into the *Controller Housing Mounting Slot*

*Insert Pic*

# Separate the *Controller Housing Base* into the *Controller Housing Mounting Slot*

# Apply super glue to the inner perimeter of the *Controller Housing Mounting Slot* where the *Controller Housing Base* will sit, taking care to keep glue out of the cut out for the slot; apply extra super glue to the large raised surface to ensure a strong bond

*Insert Pic*

# Slide the *Controller Housing Base* into the *Controller Housing Mounting Slot* and press the pieces together per the glue's instructions (typically 1 minute)

# Allow the glue to cure per its instructions

h3. 2. Solder Headers to Feather

*TBD by Bryan*

h3. 3. Assemble Controller Components

# Attach *HSC-08: TRRS Wing* to underside headers on *HSC-02: Holoseat Controller Wing*

*Insert pic*

# Attach *TRRS Wing + Controller Wing* to *Feather*

*Insert pic*

# Attach *HSC-09: Keyswitch* to *Controller Wing* (note, the LED on the *Keyswitch* should be on the left side when the *TRRS Wing* is toward you)

*Insert pic*

h3. 4. Install Firmware and Test Controller

*TBD by J. when test and firmware code is updated*

h3. 5. Final Assembly

# Insert *Feather + Wings* into *HSC-03: Controller Housing Base*

*Insert Pic*

# Attach *HSC-04: Controller Housing Top* onto *Controller Housing Base* making sure the snap fit connection fully clicks and the inset over TRRS connector seats fully into the *Controller Housing Base*

*Insert Pic*

# Attach *HSC-07: Holoseat Custom Key Cap* to *Keyswitch*

*Insert Pic*