Assembly Instructions¶

• Assembly Instructions
  • Introduction
  • Sensor Board Assembly
    • Tools
    • Materials
    • Safety Issues
    • Product
    • Procedure

Introduction¶

Below are the assembly instructions for the v0.3 Holoseat controller. This version is built using an AdaFruit Feather 32u4 Basic Proto. It also includes a remotely mountable sensor board. You will need to use your soldering skills on this build.

Sensor Board Assembly¶

Tools¶

• Diagonal Cutters
• Wire Strippers
• Needle Nose Pliers
• Soldering Iron
• Utility Knife

Materials¶

• (1) HS001 - Double-Side Prototype PCB
• (1) HS002 - Category 5e Jack
• (2) HS003 - 750 OHM 1/2W 1% Axial Resistor
• (2) HS004 - OH090U Hall Effect Sensor
• (2) HS005 - Diffused Blue 3mm LED
• Hook up wire
• CAT5 internal wire
• Solder

Safety Issues¶

• Care must be taken when using sharp hand tools to avoid cuts
• Care must be taken when using the soldering iron, the tip is very hot
• Always wear safety glasses while working with soldering irons
• Avoid breathing in the soldering fumes, use a vent or hood if needed to provide adequate ventilation

Product¶

(1) Holoseat Sensor Board

Procedure¶

.....