Holoseat

h1. Tone Ring Assembly

{{>toc}}

h2. Tools

* Permanent Marker (prefer red Sharpie brand)

* Tray/Plate

h2. Materials

* Instant/super glue (prefer Loctite Super Glue Ultragel Control)

* (1) 18PTR-01: 18 Pole Tone Ring Base

* (1) 18PTR-02: Tone Ring Cover

* (36) 18PTR-03: Magnets (*add specs!*)

* Holoseat Test Stand

h2. Safety Issues

* Take care when using the hot glue gun, especially on small objects, to avoid burns

* Use safety glasses when working with instant glue and avoid getting instant glue on skin 

h2. Product

HS-03: 18 Pole Tone Ring

h2. Procedure

h3. 1. Prep Magnets

# Stack the (36) *18PTR-03: Magnets* into a single row face to face

# Select an end of the stack to mark the faces on to identify one of the poles on all 36 magnets

# Use the permanent marker to place a dot on the selected face of the top magnet

*INSERT PIC*

# Taking care to preserve the orientation of the stack of unlabeled magnets, remove the newly labeled magnet and place marked face up on a plate with space around it to avoid it becoming connected to other magnets

# Repeat until all magnets have been marked

h3. 2. Place Magnets

# Select a magnet to attach to *18PTR-01: 18 Pole Tone Ring Base*

# Place a small dot of instant glue into one of the slots on the tone ring base and place the magnet marked face out in the slot

# Select another magnet

# Skip a slot in the tone ring base, repeat the placement step

*INSERT PIC*

# Repeat these steps(18) magnets have been placed on the tone ring base with marked face out and with empty slots between them

*INSERT PIC*

# Go back and repeat the magnet placement steps, this time with the marked face in, for each of the empty slots (they should be magnetically attracted to the slot in this orientation)

*INSERT PIC*

# Let the glue cure for at least 1 hour

h3. 3. Verify Magnet Placement

# Set up the Holoseat Test Stand

## Ensure the calibrated sensor is attached to the sensor controller

## Ensure the power and USB connections are all configured according to the test stand operating instructions

## Place the new tone ring onto the tone ring adapter

# Run test

## Clear the sensor stats

## Run the stepper motor 1 revolution, in a CW direction, at 30 RPM

## Get the sensor stats and verify the number of reported poles is 18

# Remove the tone ring from the tone ring adapter

h3. 4. Complete the Tone Ring

# ...