Tone Ring Half Assembly¶

• Tone Ring Half Assembly
  • Tools
  • Materials
  • Safety Issues
  • Product
  • Procedure
    • 1. Place Heat-Set Insert
    • 2. Place Initial Magnet
    • 3. Place Remaining Magnets
    • 4. Verify Magnet Placement
    • 5. Fix Cover to Base
  • References

Tools¶

• Holoseat Test Stand
• Magnetic Compass
• Soldering Iron with clean wide flat tip

Materials¶

• Instant/super glue (prefer Loctite Super Glue Ultragel Control)
• (1) 18PTR-01: Snap Fit 18 Pole Tone Ring Base
• (1) 18PTR-02: Snap Fit 18 Pole Tone Ring Cover
• (18) 18PTR-03: N52 3/16" x 3/16" Neodymium Cylinder Magnets
• (1) 18PTR-04: M3 x 0.5 mm Thread Size, 3.8 mm Installed Length Heat-Set Inserts for Plastics

Note: The final build requires (2) HS-03: 18 Pole Tone Ring Halves

Safety Issues¶

• Use safety glasses when working with small, high powered magnets to avoid eye injury from flying magnets
• Be sure to maintain physical control of magnets (those being placed and those already placed) to avoid flying magnets

Product¶

HS-03: 18 Pole Tone Ring Half

Procedure¶

1. Place Heat-Set Insert¶

1. ..
2. Set Soldering Iron to 350 Celsius
3. ..

2. Place Initial Magnet¶

...

3. Place Remaining Magnets¶

1. Select another magnet and find its polarity by placing it along the outside edge so that it becomes attracted to the previous magnet
2. Rotate the magnet from the previous step 180 degrees (so that the pole attracted to the previous magnet is facing out to create a pole pair) and place it in the next slot in the base
   INSERT PIC
3. Repeat the previous two steps until the tone ring is fully populated
   INSERT PIC
4. Align and place the 18PTR-02: Snap Fit Tone Ring Cover over the 18PTR-01: Snap Fit 18 Pole Tone Ring Base
5. Press the parts firmly to secure the cover to the base
   INSERT PIC

4. Verify Magnet Placement¶

Note: You will need (2) in progress HS-03: Snap Fit 18 Pole Tone Ring Halves for testing

1. Set up the Holoseat Test Stand
   1. Ensure the calibrated sensor is attached to the sensor controller
   2. Ensure the power and USB connections are all configured according to the test stand operating instructions
   3. Snap (2) in progress HS-03: Snap Fit 18 Pole Tone Ring Halves onto the tone ring adapter
      INSERT PIC
2. Run tone ring test(s)
   INSERT PIC
3. Remove the tone ring halves from the tone ring adapter

5. Fix Cover to Base¶

...

References¶

• What Are Magnetic Poles and How to Identify Them
• Reading a Compass