2017 Sprint 2 Plan

Sprint 2 of 2017 is underway. Check out the plan in this week's project news.
Added by J. Simmons 3 months ago

We just wrapped up Sprint 1 (check out our Review and Retrospective) and are ready to start Sprint 2. This sprint will continue the development work from Sprint 1 and should see us lock in on the v0.4 architecture. Of special importance is implementing the HID keyboard functionality to connect the new CHIP Pro controller board to the gaming machine. The full details of the sprint are below.

Duration: 8 weeks
Stand Ups: Wednesday nights
Start: Apr 22, 2017
End: Jun 17, 2017

Backlog and Full Sprint Plan (see Backlog and Sprint 2 tabs)

Key Development PBIs
  • DEV-07: Test Keyboard USB HID over Arduino (by way of all of its decendent PBIs)
    • DEV-26: Determine wiring to power CHIP Pro from Feather
    • DEV-27: Determine wiring to provide I2C between CHIP Pro and Feather
    • DEV-28: Develop Feather code to be I2C slave
    • DEV-29: Develop Johnny-Five code for CHIP Pro to be I2C master
    • DEV-30: Test master to slave and slave to master events between Feather and CHIP Pro
  • DEV-23: Test Nodejs then Johnny-Five in chiptainer enviroment to determine if we want to use chiptainer approach
  • DEV-25: Update Fritzing docs to migrate from CHIP to CHIP Pro (EagleCad?)
  • DEV-19: Add hot key for enable/disable of Holoseat to v0.3 Configuration App for UX testing in prep to move controller down to the exercise equipment and remove separate sensor board
  • DEV-31: Send out note to fans asking for input about hotkey vs button for enable/disable
Pre-Sprint Commitments
  • J
    • Drafting blog post about Sprint 1 and 2
    • DEV-23: Test Nodejs then Johnny-Five in chiptainer enviroment to determine if we want to use chiptainer approach - start testing work and document what we know
  • Bryan
    • DEV-25: Update Fritzing docs to migrate from CHIP to CHIP Pro (EagleCad?) - research options to include CHIP Pro in electrical schematics (may include work on DEV-24)

Comments