« Previous -
Version 2/20
(diff) -
Next » -
Current version
J. Simmons, 12/12/2016 04:33 pm
Software Set Up¶
Introduction¶
three pieces of software to install for first time builds, four steps
1. Get Firmware Source Code¶
the source code has the libs we need in step 2
2. Install Arduino IDE¶
must install and configure for Feather and libs
3. Install Firmware on Holoseat Controller¶
connect the controller, find the com port, load the project, compile, flash
4. Install Desktop Configuration App¶
unzip archive to <insert path here>
