« Previous -
Version 5/16
(diff) -
Next » -
Current version
J. Simmons, 04/30/2018 06:47 pm
Sensor Assembly¶
Tools¶
- Holoseat Test Stand with computer to operate it
- Soldering iron with stand
- Helping hands
- Exhaust fan
- Sensor assembly jig (3D printed tool - provide link)
- Flush snips
- Safety glasses
Materials¶
- Instant/super glue (prefer Loctite Super Glue Ultragel Control)
- Solder
- (1) WSSM-01: TRRS Audio Connector PCB
- (1) WSSM-02: TLE4966L Infineon Technologies High Precsn Hall / Board Mount Hall Effect/Magnetic Sensor
- (1) WSSM-03: Sensor Housing Lower Half
- (1) WSSM-04: Sensor Housing Upper Half
- (1) WSSM-05: 3M 9472LE Tape 1/2" x 1" piece
Safety Issues¶
- Care must be taken when using the soldering iron, the tip is very hot
- Always wear safety glasses while working with soldering irons
- Avoid breathing in the soldering fumes, use a vent or hood if needed to provide adequate ventilation
Product¶
HS-04: Wheel Speed Sensor Module
Procedure¶
1. Place sensor on TRRS Audio Connector PCB¶
- Place WSSM-02: TLE4966L Sensor in jig with label facing “out” (toward window in jig)
- Slide TLE4966L Sensor into jig until its label aligns can be seen through the window in jig
- Bend TLE4966L Sensor leads down along jig
- Place TLE4966L Sensor pins through holes in WSSM-01: TRRS Audio Connector PCB with the jack facing up
- Align TRRS Audio Connector PCB with lip on jig
- Bend TLE4966L Sensor leads over to fix position of sensor relative TRRS Audio Connector PCB
- Remove TLE4966L Sensor/TRRS Audio Connector PCB sub-assembly from jig
INSERT VIDEO of Step 1 Procedure Here
2. Solder TLE4966L Sensor to TRRS Audio Connector PCB¶
- Place TLE4966L Sensor/TRRS Audio Connector PCB sub-assembly in helping hands
Insert Pic - Solder all 4 TLE4966L Sensor leads to their pins on the TRRS Audio Connector PCB
- Trim back excess leads from TLE4966L Sensor
Insert Pic
3. Verify sensor¶
- Place TLE4966L Sensor/TRRS Audio Connector PCB sub-assembly in WSSM-03: Sensor Housing Lower Half
Insert Pic - Connect sensor cable from test stand to Wheel Speed Sensor sub-assembly
- Place Wheel Speed Sensor sub-assembly in sensor mount on test stand
Insert Pic - Run tests - see test stand for API calls/application used for these tests
- Verify direction
- it should report cw when wheel turns 20 rpm cw
- it should report ccw when wheel turns 20 rpm ccw
- Verify cadence
- it should report 30 +/- 10% when wheel turns cw at 30 rpm
- it should report 45 +/- 15% when wheel turns cw at 45
- Verify direction