Lab Journal
Version 5 (Andrew Starr, 10/19/2012 10:09 pm)
| 1 | 1 | Andrew Starr | h1. Lab Journal |
|---|---|---|---|
| 2 | 2 | Andrew Starr | |
| 3 | 2 | Andrew Starr | h2. 20 Oct, 2012 - Tunnelling Current Amplifier simulation |
| 4 | 2 | Andrew Starr | |
| 5 | 2 | Andrew Starr | The tunnelling current amplifier is an example of a _transimpedance_ amplifier: it converts a current input into a voltage output. This amplifier is a critical circuit in the microscope, so I have taken advantage of available electronic simulation software to test and tune the design before committing to a PCB. |
| 6 | 2 | Andrew Starr | |
| 7 | 2 | Andrew Starr | h3. Bandwidth vs noise |
| 8 | 2 | Andrew Starr | |
| 9 | 3 | Andrew Starr | In a transimpedance amplifier there is an unavoidable tradeoff between the bandwidth of the amplifier response and its output noise. The higher the bandwidth of the amplifier, the faster the response, but also the higher the output noise will be. These two parameters have the following effects on the microscope performance: |
| 10 | 3 | Andrew Starr | |
| 11 | 3 | Andrew Starr | # Bandwidth affects response time of the amplifier to a change in tunnelling current, and therefore affects the rate at which the sample can be scanned. |
| 12 | 3 | Andrew Starr | # Noise affects the vertical resolution of the tunnelling current, and therefore limits the vertical resolution of the sample data. If the noise is bad enough it may also cause problems in maintaining the tip-sample tunnelling distance. |
| 13 | 4 | Andrew Starr | |
| 14 | 4 | Andrew Starr | h3. Simple vs composite amplifier |
| 15 | 5 | Andrew Starr | |
| 16 | 5 | Andrew Starr | The 'classic' transimpedance amplifier design for small currents such as photodiodes etc is an op-amp with negative feedback via a single large value resistor, with a compensation capacitor to prevent oscillation due to noise gain: |