Operating Manual v1 0
Version 4 (Jeremy Wright, 09/20/2012 10:44 pm) → Version 5/49 (Jeremy Wright, 09/20/2012 10:47 pm)
h1. Operating Manual v1.0
h2. Unpacking After Transport
* Check shipping container(s) for:
** Test stand
** Concrete block
** Box of accessories
*** Launch controller
*** D motor spacer ring
*** Motor mount adapters (A, B, and C to D/E size)
*** Thermocouple attachment tape (high temp)
** Computer and USB cable
** Motors to test (with igniters and igniter plugs)
** Fire extinguisher and maybe a bucket for water water.
h2. Test Stand Setup
* Place concrete block in location where test stand will be operated
* Set test stand on concrete block
* Create the safety perimeter.
** Delineate no stand zone for both proximity and positions
*** Use length of cord for the igniter (radius of operations)
*** Exclusion zones exist behind where exhaust escapes (30 degree cone), and in front on each side of the exhaust T (30 degree cone on each side)
h2. Unpacking After Transport
* Check shipping container(s) for:
** Test stand
** Concrete block
** Box of accessories
*** Launch controller
*** D motor spacer ring
*** Motor mount adapters (A, B, and C to D/E size)
*** Thermocouple attachment tape (high temp)
** Computer and USB cable
** Motors to test (with igniters and igniter plugs)
** Fire extinguisher and maybe a bucket for water water.
h2. Test Stand Setup
* Place concrete block in location where test stand will be operated
* Set test stand on concrete block
* Create the safety perimeter.
** Delineate no stand zone for both proximity and positions
*** Use length of cord for the igniter (radius of operations)
*** Exclusion zones exist behind where exhaust escapes (30 degree cone), and in front on each side of the exhaust T (30 degree cone on each side)