Software Set Up
Version 1 (J. Simmons, 12/06/2016 07:12 am) → Version 2/20 (J. Simmons, 12/12/2016 04:33 pm)
h1. Software Set Up
{{>toc}}
h2. Introduction
three pieces of software to install Add instructions for first time builds, four steps
h2. 1. Get Firmware Source Code
the source code has the libs we need in step 2
h2. 2. Install Arduino IDE
must install installing firmware and configure for Feather and libs
h2. 3. Install Firmware on Holoseat Controller
connect the controller, find the com port, load the project, compile, flash
h2. 4. Install Desktop Configuration App
unzip archive to <insert path here> desktop app
{{>toc}}
h2. Introduction
three pieces of software to install Add instructions for first time builds, four steps
h2. 1. Get Firmware Source Code
the source code has the libs we need in step 2
h2. 2. Install Arduino IDE
must install installing firmware and configure for Feather and libs
h2. 3. Install Firmware on Holoseat Controller
connect the controller, find the com port, load the project, compile, flash
h2. 4. Install Desktop Configuration App
unzip archive to <insert path here> desktop app