Alpha Patch 1 - Sensor Housing Fix
Version 3 (J. Simmons, 08/28/2018 12:41 am)
| 1 | 1 | J. Simmons | h1. Alpha Patch 1 - Sensor Housing Fix |
|---|---|---|---|
| 2 | 1 | J. Simmons | |
| 3 | 1 | J. Simmons | {{>toc}} |
| 4 | 1 | J. Simmons | |
| 5 | 1 | J. Simmons | h2. Tools |
| 6 | 1 | J. Simmons | |
| 7 | 1 | J. Simmons | * Large household scissors |
| 8 | 1 | J. Simmons | |
| 9 | 1 | J. Simmons | h2. Materials |
| 10 | 1 | J. Simmons | |
| 11 | 1 | J. Simmons | * Holoseat sensor module |
| 12 | 1 | J. Simmons | |
| 13 | 1 | J. Simmons | h2. Safety Issues |
| 14 | 1 | J. Simmons | |
| 15 | 1 | J. Simmons | * Take care to avoid having flying plastic pieces get in your eyes |
| 16 | 1 | J. Simmons | |
| 17 | 1 | J. Simmons | h2. Product |
| 18 | 1 | J. Simmons | |
| 19 | 1 | J. Simmons | This patch is to remove the nib on the front of the Holoseat sensor module. Before implementing the patch the sensor module will look like this: |
| 20 | 1 | J. Simmons | |
| 21 | 3 | J. Simmons | !before_md.jpg! |
| 22 | 1 | J. Simmons | |
| 23 | 1 | J. Simmons | After implementing the patch it will look like this: |
| 24 | 1 | J. Simmons | |
| 25 | 3 | J. Simmons | !after_md.jpg! |
| 26 | 1 | J. Simmons | |
| 27 | 1 | J. Simmons | h2. Procedure |
| 28 | 1 | J. Simmons | |
| 29 | 1 | J. Simmons | # Use scissors to cut the nib off. Start with the adhesive side of the sensor pointing down. |
| 30 | 3 | J. Simmons | !step1_md.jpg! |
| 31 | 1 | J. Simmons | # Rotate 90 degrees and cut again. |
| 32 | 3 | J. Simmons | !step2_md.jpg! |
| 33 | 1 | J. Simmons | # Repeat until the nib has been (mostly) removed. |