Assembly Instructions¶

• Assembly Instructions
  • Introduction
  • Test Stand Body Assembly
    • Tools - Test Stand Body
    • Materials - Test Stand Body
    • Safety Issues - Test Stand Body
    • Product - Test Stand Body
    • Procedure - Test Stand Body

Introduction¶

TBD

Test Stand Body Assembly¶

Tools - Test Stand Body¶

• Mitre Saw (preferably powered)
• Pencil
• Carpentry square
• Tape Measure
• Screw Gun
• 1/16" Drill bit (for TS-07: 1-1/4" Fine Thread Drywall Screws)
• 1/8" Drill bit (for TSB-03: #9 x 2-1/2" Coarse Thread Drywall Screws)
• Phillips screw driving bit
• (2) 12" (or larger) Bar clamps

Materials - Test Stand Body¶

• (2) TSB-01: Side Boards
• (2) TSB-02: Top Boards
• (6) TSB-03: #9 x 2-1/2" Coarse Thread Drywall Screws
• (1) TSB-04: 36" Long 2x3 Board
• (1) TS-06: Nema 17 Stepper Motor Mount
• (4) TS-07: 1-1/4" Fine Thread Drywall Screws
• TSB-05: Semi-gloss latex paint

Safety Issues - Test Stand Body¶

• Always wear safety glasses when working with carpentry tools
• Take care when using saws (especially power saws)

Product - Test Stand Body¶

(1) TS-01: Holoseat Test Stand Body

Procedure - Test Stand Body¶

1. Produce Side and Top Boards
   1. Use a miter saw to cut (2) 12" long boards from TSB-04: 36" Long 2x3 Board to produce (2) TSB-01: Side Boards
      (also requires tape measure, carpentry square, and pencil)
   2. Use a miter saw to cut (2) 5" long boards from TSB-04: 36" Long 2x3 Board to produce (2) TSB-02: Top Boards
      (also requires tape measure, carpentry square, and pencil)
2. ...