Holoseat » Holoseat Test Stand

h1. Assembly Instructions

{{toc}}

h2. Introduction

TBD

h2. Test Stand Body Assembly

h3. Tools - Test Stand Body

* Mitre Saw (preferably powered)
* Pencil
* Carpentry square
* Tape Measure
* Screw Gun
* 1/16" Drill bit (for TS-07: 1-1/4" Fine Thread Drywall Screws)
* 1/8" Drill bit (for TSB-03: @#9@ x 2-1/2" Coarse Thread Drywall Screws)
* Phillips screw driving bit
* (2) 12" (or larger) Bar clamps

h3. Materials - Test Stand Body

* (2) TSB-01: Side Boards
* (2) TSB-02: Top Boards
* (6) TSB-03: #9 x 2-1/2" Coarse Thread Drywall Screws
* (1) TSB-04: 36" Long 2x3 Board
* (1) TS-06: Nema 17 Stepper Motor Mount
* (4) TS-07: 1-1/4" Fine Thread Drywall Screws
* TSB-05: Semi-gloss latex paint



h3. Safety Issues - Test Stand Body

* Always wear safety glasses when working with carpentry tools
* Take care when using saws (especially power saws) TBD

h3. Product - Test Stand Body

(1) TS-01: Holoseat Test Stand Body

h3. Procedure - Test Stand Body

# Produce Side and Top Boards
## Use a miter saw to cut (2) 12" long boards from *TSB-04: 36" Long 2x3 Board* to produce (2) *TSB-01: Side Boards*
(also requires tape measure, carpentry square, and pencil)
## Use a miter saw to cut (2) 5" long boards from *TSB-04: 36" Long 2x3 Board* to produce (2) *TSB-02: Top Boards*
(also requires tape measure, carpentry square, and pencil)
# ... TBD