Holoseat

J's Report

• Did
  • BIZ-03: Generate required reports and confirm accuracy - done and filed
  • DEV-02: Determine if we should use a tone ring vs. existing single magnet design - done, see notes and recommendations
  • CAMP-03: Review docs for new campaigns on Crowd Supply's website - completed (notes in Google Drive), will mark done after discussing with Bryan
• Will do
  • DEV-14: Develop outline for on boarding process - meeting with Bryan Fri night to knock this task out
  • Document material from Make Magazine article about crowd funding - read this article last week, will take some notes about it
  • Post some architecture notes I have been writing up to forums for public discussion
  • BIZ-06: Determine what paperwork must be filed to add an owner - will start researching this
• Blocked?
  • Next week will be on travel again, so need to get things taken care of by Sun

Bryan's Report

• Did
  • DEV-06: Test Keyboard USB HID over USB-Gadget - Read more than half of the book on Docker.
  • CAMP-01: Review articles/information from Fred Hicks regarding kickstarter campaigns - Did some of this, but not much additional
  • DEV-03: Fix Bug #276 (Sensors are 5v logic feeding into 3.3v inputs on the controller) - Worked on setting up the electronics (pins 2 and 3 go to Vlow on the board then run to the sensor set. Ground should be routed through the board.) Still need a multi-meter
• Will do
  • DEV-06: Test Keyboard USB HID over USB-Gadget - Will start looking at Docker USB-Gadget image I came across earlier
  • DEV-03: Fix Bug #276 (Sensors are 5v logic feeding into 3.3v inputs on the controller) - purchase multimeter
  • CAMP-01: Review articles/information from Fred Hicks regarding kickstarter campaigns - plan to finish reviewing/documenting Fred Hicks articles
• Blocked?
  • DEV-03: Fix Bug #276 (Sensors are 5v logic feeding into 3.3v inputs on the controller) - Cannot proceed without a multi-meter