2017 Sprint 1 Stand Up 4

Getting back on track and knocking out some of the administrative PBIs.
Added by J. Simmons almost 9 years ago

It hasn't been a full week since our last stand up, so the reports are a little shorter than usual. Still, we are making progress again and are looking pretty good as we pass the half way mark.

J's Report

  • Did
    • DEV-02: Determine if we should use a tone ring vs. existing single magnet design - documented research and getting close to reaching a conclusion (looks very likely that we will want to move to a commercial sensor/tone ring combination)
    • Get newsletter published - worked with Ingrid, expect to publish in the next day or so
    • BIZ-09: Submit books for tax accounting - packaged and sent materials to accountant (our end is basically done, but won't claim done until accountant sends back tax paperwork)
  • Will do
    • BIZ-03: Generate required reports and confirm accuracy - will review Bryan's documentation and prepare annual report
    • DEV-02: Determine if we should use a tone ring vs. existing single magnet design - complete research and document results
    • CAMP-03: Review docs for new campaigns on Crowd Supply's website - will locate and review Crowd Supply materials
  • Blocked?
    • on travel through Sat, will need some time to recover Sun/Mon, so still not overloading commitments

Bryan's Report

  • Did
    • BIZ-05: Create LLC documentation covering regular reporting requirements (what, when, how, where) - done, doc is on Google drive
    • DEV-06: Test Keyboard USB HID over USB-Gadget - read up more on Docker
    • CAMP-01: Review articles/information from Fred Hicks regarding kickstarter campaigns - started reading, taking notes on google drive
    • DEV-03: Fix Bug #276 (Sensors are 5v logic feeding into 3.3v inputs on the controller) - attached pins to put together breadboard for testing
  • Will do
    • DEV-06: Test Keyboard USB HID over USB-Gadget - more reading about Docker
    • CAMP-01: Review articles/information from Fred Hicks regarding kickstarter campaigns - more reading and note taking
    • DEV-03: Fix Bug #276 (Sensors are 5v logic feeding into 3.3v inputs on the controller) - look over circuit and figure out how to insert the breadboard in the middle w/ voltage step chip
  • Blocked?
    • not sure if there is time to commit to anything else

Comments

Added by Nehemiah Mike about 7 years ago

Do some testing before you hand over the project to your client because it is important for you to do that. The custom essay paper writing service tell us few reasons why we need to do that. And this is the best approach for you.