PY18 Sprint 2 Stand Up 3

Another week, another glitch. But we are still making steady progress toward completing the Alpha builds.
Added by J. Simmons 4 months ago

  • J's Report*
  • Did
    • SME-08: Publish at least one blog post in Jan. - published this post
    • V04-28: Design a housing in Fusion 360 for the sensor and TRRS jack (Sensor Housing) - All but done
    • V04-13: Test the tone rings against the behavior of the existing 12 pole 3D printed design (at least same performance, but looking for faster response times and improved single stepping) - discovered issue with magnet strength while testing sensor inside sensor housing; began redesign of tone ring for stronger magnets and sourced new magnets
  • Will do
    • V04-13: Test the tone rings against the behavior of the existing 12 pole 3D printed design (at least same performance, but looking for faster response times and improved single stepping) - order small batch of new magnets for R&D of tone ring
    • V04-58: Implement hardware versioning system that can be detected by Holoseat software - start reorganizing wiki pages around about page/versioning plan
    • SME-09: Publish at least one blog post in Feb - start drafting last post in current series
    • V04-26: Assemble a test Wings to verify design (on proto-wing) - send Bryan ohm arduino sketch to verify hw version circuit
  • Blocks?
    • none, but at reduced capacity due to travel (need to reschedule stand up)

Bryan's Report

  • Did
    • V04-26: Assemble a test Wings to verify design (on proto-wing) - fixed TRRS jack wiring and added version circuit on board 1 (board 1 is complete)
    • BIZ-03: Work with Legal on Trademark Filing - met with J, gave feedback to graphic artist about image fixes (waiting for updates), gave go ahead to legal
    • V04-13: Test the tone rings against the behavior of the existing 12 pole 3D printed design (at least same performance, but looking for faster response times and improved single stepping) - dropped due to findings above
    • BIZ-06: Meet with SBDC Innovation and Commercialization Assistance Program - done
  • Will do
    • V04-23: Modify Adafruit Wing to handle the required components and have the necessary headers - research board layout and start layout work
  • Blocks?
    • none

Comments

Added by Mary Henderson 4 months ago

Content composition is very fascinating work who are in this work are truly appreciate the work. You ought to have huge learning about all the common things and subjects. The [[https://usawriters.org/]] discloses to us the estimation of this work for the future in light of the fact that numerous authors are getting a charge out of good life.