Workbench Assembly Instructions¶
Assemble the top¶
- Mark framing (2x Part A) at 16" and 32" so you can line up the top's framing
- Assemble the top's frame (4x Part B between 2x Part A) using 2-1/2" sheetrock screws
- Align the clamp edges on the end of the short sides (this should create a frame that is 4'x4')
- Use clamps to hold the clamp edges in place and attach them to the from using 2-1/2" sheetrock screws (screw from the inside of the frame into the clamp edge)
- Turn the frame over and place the plywood top (Part D) on the top's frame.
- Attach the plywood top to the frame with 2" sheetrock screws
Attach the legs¶
- Turn the top over and attach the four legs (Part C) to the frame using 4 2-1/2" sheetrock screws.
----------------------------------------------------------------------------------------------------
- Measure 10" down from the "bottom" of the legs (currently at the top of the assembly) and mount 2 supports (Part B) across from one another using 2-1/2" sheetrock screws.
- Attach the last 2 supports (Part A) on the other two sides of the legs next to the first two supports using 2-1/2" sheetrock screws.
----------------------------------------------------------------------------------------------------