Open Design Engine

11/02/2013

06:33 pm CNC Mill: 4x8 Wood (<$500), Fresno Ideaworks Milestone #232 (New): Build the X and Y axes

06:32 pm CNC Mill: 4x8 Wood (<$500), Fresno Ideaworks Milestone #231 (New): Build the Y axis

06:31 pm CNC Mill: 4x8 Wood (<$500), Fresno Ideaworks Milestone #230 (New): Design X and Y axes

Movement along the X axis (the shorter of the two axes determining lateral position) will be controlled with a 5-foot...

06:14 pm CNC Mill: 4x8 Wood (<$500), Fresno Ideaworks Milestone #229 (New): Flash an ATMEGA328 with grbl firmware

06:12 pm CNC Mill: 4x8 Wood (<$500), Fresno Ideaworks Milestone #228 (New): Design the base (table)

At least draw a picture and estimate the amount of material required.

06:10 pm CNC Mill: 4x8 Wood (<$500), Fresno Ideaworks Milestone #227 (New): Build the base (table)

The table must be large and sturdy enough to accept whole 4x8 sheets of plywood, and support mounting of motors, axes...

05:27 pm CNC Mill: 4x8 Wood (<$500), Fresno Ideaworks Milestone #226 (In Progress): Assemble Stepper Motor Driver Boards

We have three unassembled Linistepper (http://www.piclist.com/techref/io/stepper/linistep) open source stepper motor ...