Calibration
Version 1 (Matt Maier, 08/16/2014 05:40 pm) → Version 2/6 (Matt Maier, 08/16/2014 06:50 pm)
pre-first-print non-recurring
motor current (correct stepper motor current)
axes (all axes parallel/perpendicular)
bed surface (ensure proper plastic adhesion)
bed level (extruder the same height at all points on bed)
Z steps/mm
extruder temperature
extruder steps/mm
post-first-print
XY steps/mm
layer height (adjust by .01 till beautiful)
infill (1.0 solid cube)
references
* http://reprap.org/wiki/Calibration recurring
motor current (correct stepper motor current)
axes (all axes parallel/perpendicular)
bed surface (ensure proper plastic adhesion)
bed level (extruder the same height at all points on bed)
Z steps/mm
extruder temperature
extruder steps/mm
post-first-print
XY steps/mm
layer height (adjust by .01 till beautiful)
infill (1.0 solid cube)
references
* http://reprap.org/wiki/Calibration recurring