Edit History

Calibration

Version 2 (Matt Maier, 08/16/2014 06:50 pm)

1 2 Matt Maier 
pre-first-print
2 1 Matt Maier 






    3
    2
    Matt Maier
    
motor current (correct stepper motor current)






    4
    2
    Matt Maier
    
axes (all axes parallel/perpendicular)






    5
    2
    Matt Maier
    
bed surface (ensure proper plastic adhesion)






    6
    2
    Matt Maier
    
bed level (extruder the same height at all points on bed)






    7
    2
    Matt Maier
    
Z steps/mm






    8
    2
    Matt Maier
    
extruder temperature






    9
    2
    Matt Maier
    
extruder steps/mm






    10
    2
    Matt Maier
    






    11
    2
    Matt Maier
    
post-first-print






    12
    2
    Matt Maier
    






    13
    2
    Matt Maier
    
XY steps/mm






    14
    2
    Matt Maier
    
layer height (adjust by .01 till beautiful)






    15
    2
    Matt Maier
    
infill (1.0 solid cube)






    16
    2
    Matt Maier
    






    17
    2
    Matt Maier
    






    18
    2
    Matt Maier
    
references






    19
    2
    Matt Maier
    
* http://reprap.org/wiki/Calibration