Workbench Instructions¶

1. Assemble the top
   1. Mark framing (2x Part A) at 16" and 32" so you can line up the top's framing
      
   2. Assemble the top's frame (4x Part B between 2x Part A) using 2-1/2" sheetrock screws
      
   3. Align the clamp edges on the end of the short sides (this should create a frame that is 4'x4')
      
   4. Use clamps to hold the clamp edges in place and attach them to the from using 2-1/2" sheetrock screws (screw from the inside of the frame into the clamp edge)
      
   5. Turn the frame over and place the plywood top (Part D) on the top's frame.
      
   6. Attach the plywood top to the frame with 2" sheetrock screws
      
2. Attach the legs
   1. Turn the top over and attach the four legs (Part C) to the frame using 4 2-1/2" sheetrock screws.
      
      
   2. Measure 10" down from the "bottom" of the legs (currently at the top of the assembly) and mount 2 supports (Part B) across from one another using 2-1/2" sheetrock screws.
      
   3. Attach the last 2 supports (Part A) on the other two sides of the legs next to the first two supports using 2-1/2" sheetrock screws.
3. Turn over the table and enjoy