WorkbenchInstructions
Version 2 (J. Simmons, 10/14/2011 12:52 am) → Version 3/8 (J. Simmons, 10/14/2011 12:53 am)
h1. Workbench Instructions
# *Assemble the top*
## Mark framing (2x Part A) at 16" and 32" so you can line up the top's framing
!step1_1.jpg!
## Assemble the top's frame (4x Part B between 2x Part A) using 2-1/2" sheetrock screws
!step1_2.jpg!
## Align the clamp edges on the end of the short sides (this should create a frame that is 4'x4')
!step1_3.jpg!
## Use clamps to hold the clamp edges in place and attach them to the from using 2-1/2" sheetrock screws (screw from the inside of the frame into the clamp edge)
!step1_4.jpg!
## Turn the frame over and place the plywood top (Part D) on the top's frame.
!step1_5.jpg!
## Attach the plywood top to the frame with 2" sheetrock screws
!step1_6.jpg!
# *Attach the legs*
## Turn the top over and attach the four legs (Part C) to the frame using 4 2-1/2" sheetrock screws.
!step2_1.jpg!
!step2_2.jpg!
## Measure 10" down from the "bottom" of the legs (currently at the top of the assembly) and mount 2 supports (Part B) across from one another using 2-1/2" sheetrock screws.
!step2_3.jpg!
## Attach the last 2 supports (Part A) on the other two sides of the legs next to the first two supports using 2-1/2" sheetrock screws.
# ## Turn over the table and enjoy enjoy.
# *Assemble the top*
## Mark framing (2x Part A) at 16" and 32" so you can line up the top's framing
!step1_1.jpg!
## Assemble the top's frame (4x Part B between 2x Part A) using 2-1/2" sheetrock screws
!step1_2.jpg!
## Align the clamp edges on the end of the short sides (this should create a frame that is 4'x4')
!step1_3.jpg!
## Use clamps to hold the clamp edges in place and attach them to the from using 2-1/2" sheetrock screws (screw from the inside of the frame into the clamp edge)
!step1_4.jpg!
## Turn the frame over and place the plywood top (Part D) on the top's frame.
!step1_5.jpg!
## Attach the plywood top to the frame with 2" sheetrock screws
!step1_6.jpg!
# *Attach the legs*
## Turn the top over and attach the four legs (Part C) to the frame using 4 2-1/2" sheetrock screws.
!step2_1.jpg!
!step2_2.jpg!
## Measure 10" down from the "bottom" of the legs (currently at the top of the assembly) and mount 2 supports (Part B) across from one another using 2-1/2" sheetrock screws.
!step2_3.jpg!
## Attach the last 2 supports (Part A) on the other two sides of the legs next to the first two supports using 2-1/2" sheetrock screws.
# ## Turn over the table and enjoy enjoy.