Holoseat

J's Report

• Did
  • Published blog post about Sprint 1 and 2
  • Get access to mailing list account - I found part of the required info
  • DEV-23: Test Nodejs then Johnny-Five in chiptainer enviroment to determine if we want to use chiptainer approach - got Docker running (and shared the news), but did not get the CHIPtainer examples running (the Docker files point to a private repo I cannot get an account for)
  • DEV-25: Update Fritzing docs to migrate from CHIP to CHIP Pro (EagleCad?) - created an account for Circuit Maker and reviewed the stub Holoseat project (added some content and reviewed what was there)
  • DEV-26: Determine wiring to power CHIP Pro from Feather - documented initial research
  • DEV-27: Determine wiring to provide I2C between CHIP Pro and Feather - documented initial research
  • BIZ-07: Submit paperwork to adjust ownership to the appropriate entities - met with Bryan and got the last internal paperwork signed
• Will do
  • Get access to mailing list account - finish this
  • BIZ-07: Submit paperwork to adjust ownership to the appropriate entities - scan and file the last paperwork (then we can claim done)
  • DEV-23: Test Nodejs then Johnny-Five in chiptainer enviroment to determine if we want to use chiptainer approach - figure out how to get the CHIPtainer examples running without access to the NTC's private repo
  • DEV-26: Determine wiring to power CHIP Pro from Feather - solder pins onto Feather, CHIP Pro, and new bread board CAT5 jacks
• Blocked?
  • DEV-23: Test Nodejs then Johnny-Five in chiptainer enviroment to determine if we want to use chiptainer approach - no response so far to the issue I reported about the CHIPtainer examples however, after reviewing the CHIPtainer docker files, I think I understand enough that I can make them work

Bryan's Report

• Did
  • DEV-25: Update Fritzing docs to migrate from CHIP to CHIP Pro (EagleCad?) - A bit more setup with Circuit Maker, put supplemental files for WINE install on private google drive folder.
• Will do
  • DEV-25: Update Fritzing docs to migrate from CHIP to CHIP Pro (EagleCad?) - Continue documentation work
  • Write blog post about our decision to go with circuit maker instead of other tools for schematics
• Blocked?
  • Travel for day job