statement of intent
assumptions

Hokay, so. I'm going to start by collecting a bunch of the links I've been keeping track of.

• reprap.org (wiki)
  • calibration
  • software tweaking manual
  • triffid hunter's calibration guide
  • print troubleshooting pictorial guide
  • leveling the bed
• the3dprinter.blogspot.com
  • firmware calibration
  • skeinforge settings
  • print calibration
  • filament tips
  • tools
  • troubleshooting
• fabmetheus.crsndoo.com
  • skeinforge manual
• thingiverse
  • calibrate parts to fit
  • calibrate for part fitting
  • bed leveling calibration
  • calibration set
  • print temperature calibration
• slic3r manual
• building a 3d printer
  • extruder calibration
• richrap.blogspot.com
  • slic3r is nicer part 1
  • slic3r is nicer part 2
  • slic3r is nicer part 3
• solidoodletips
  • setting the flow rate
• just print 3d
  • prelude to calibration
  • calibration basic 1
  • calibration basic 2
• ultimaker
  • troubleshooting
  • visual ultimaker troubleshooting
• minow
  • calibrating a delta printer
• hydraraptor (nophead
  • hole size
• miscellaneous
  • diagram of print cross section
  • calibrating reprap
  • 10 rules for top notch prints