Tone Ring Assembly¶

• Tone Ring Assembly
  • Tools
  • Materials
  • Safety Issues
  • Product
  • Procedure
    • 1. Place Magnets
    • 3. Verify Magnet Placement
    • 4. Complete the Tone Ring

Tools¶

• Holoseat Test Stand

Materials¶

• (optional) Instant/super glue (prefer Loctite Super Glue Ultragel Control)
• (1) 18PTR-01: 18 Pole Tone Ring Base
• (1) 18PTR-02: Tone Ring Cover
• (36) 18PTR-03: N52 3/16" x 3/16" Neodymium Cylinder Magnets

Safety Issues¶

• Use safety glasses when working with small, high powered magnets to avoid eye injury from flying magnets

Product¶

HS-03: 18 Pole Tone Ring

Procedure¶

1. Place Magnets¶

1. TBD

3. Verify Magnet Placement¶

1. Set up the Holoseat Test Stand
   1. Ensure the calibrated sensor is attached to the sensor controller
   2. Ensure the power and USB connections are all configured according to the test stand operating instructions
   3. Place the new tone ring onto the tone ring adapter
2. Run test
   1. Clear the sensor stats
   2. Run the stepper motor 1 revolution, in a CW direction, at 30 RPM
   3. Get the sensor stats and verify the number of reported poles is 18
3. Remove the tone ring from the tone ring adapter

4. Complete the Tone Ring¶

1. Align and place the 18PTR-02: Tone Ring Cover over the 18PTR-01: 18 Pole Tone Ring Base
2. Press the parts firmly to secure the cover to the base