h1. Controller Assembly

{{>toc}}

h2. Tools

* Holoseat Test Stand with computer to operate it
* Soldering iron with stand
* Helping hands
* Exhaust fan
* Flush snips
* Safety glasses

h2. Materials

* Instant/super glue (prefer Loctite Super Glue Ultragel Control)
* Solder
* (1) HSC-01: Feather
* (1) HSC-02: Holoseat Controller Wing
* (1) HSC-03: Controller Housing Base
* (1) HSC-04: Controller Housing Top
* (1) HSC-05: 12 pin header
* (1) HSC-06: 16 pin header
* (1) HSC-07: Holoseat Custom Key Cap
* (1) HSC-08: TRRS Wing
* (1) HSC-09: Keyswitch
* (1) HSC-10: Controller Housing Mounting Slot

h2. Safety Issues

* Care must be taken when using the soldering iron, the tip is very hot
* Always wear safety glasses while working with soldering irons
* Avoid breathing in the soldering fumes, use a vent or hood if needed to provide adequate ventilation

h2. Product

HS-02: Controller

h2. Procedure

h3. 1. Prepare Mounting Slot

# ..

h3. 2. Solder Headers to Feather

*TBD by Bryan*

h3. 3. Assemble Controller Components

# Attach *HSC-08: TRRS Wing* to underside headers on *HSC-02: Holoseat Controller Wing*
*Insert pic*
# Attach *TRRS Wing + Controller Wing* to *Feather*
*Insert pic*
# Attach *HSC-09: Keyswitch* to *Controller Wing*
*Insert pic*

h3. Test Controller

*TBD by J. when test and firmware code is updated*

h3. Final Assembly

# Insert *Feather + Wings* into *HSC-03: Controller Housing Base*
*Insert Pic*
# Attach *HSC-04: Controller Housing Top* onto *Controller Housing Base* making sure the snap fit connection fully clicks and the inset over TRRS connector seats fully into the *Controller Housing Base*
*Insert Pic*
# Attach *HSC-07: Holoseat Custom Key Cap* to *Keyswitch*
*Insert Pic*